Get either a Hakko FX888D or a Weller WES51. I personally prefer the Hakko, but both are excellent stations that cost under $150 which will serve you for years if you take care of them.
A note - soldering stations usually come with a cheap conical tip as a starter tip. Pay an extra $20 or so to buy two chisel tips: a tiny one for fine work, and a big one for larger work. The flat surface allows you to apply more heat to the joint. Take care of your tips (ie: keep them tinned, don't leave the iron on too hot, and don't scrub too hard with the brass sponge) and the tips should last a few years without trouble.
A thing to say in Weller's favour: They stock parts forever. My Weller station is somthing like 35 years old, now, still works perfectly. But someone damaged the sleeve that holds the tips in place. No problem, for a modest cost I could still buy a replacement, even though that particular part no longer fits any contemporary model of iron Weller sells. Kudos to them!
The WES51 as a solid soldering iron. You can get ones with a display readout but it's less useful than you might think. Most of the time you just set the temp and then switch tips if you need more or less heat transfer. Need to solder something large or stubborn? Using a phat chisel tip is better than upping the temp. Too hot and the rosin quickly oxidizes and turns to varnish, which prevents the solder from wetting.
Also tips, get a hooked tip, about 80% of the time it'll do the job.
YiHUA (or other genetic Chinese brand) 936B clones are plenty cheap (less than $30 shipped IIRC) and are actually quite good.
Yes, the Hakko's are really nice and quality, but the Chinese clones are honestly 'good enough' for many people. They're workhorse machines that see tons of use in their native market.
I recommend the TS100 (<$100 budget) and JBC ($300-$500 budget). After getting a decent soldering iron I never looked back. Yes its expensive, but so are the parts you destroy with the crappy $30 irons, or the frustration of soldering big copper pads and the tip cooling down in the middle of the process.
Regarding the JBC, after the initial investment, various the tips (chinese clones ~$5 or even originals ~$25) add so much incremental value to the soldering iron base for such a little extra cost.
Hakko and Weller are a solid choice, but I purchased a programmable TS100 last year and haven't looked back since. I solder a lot on drones and it's just delightful to work with: so light, quick to heat, it has an OLED screen built in, changeable tips and it's programmable. All that for under $50 there's nothing that I would recommend more.
If you're soldering for a living there are probably better suited soldering stations, but if you're just starting out: get this one.
Also: don't skimp on tin. Good quality soldering tin makes a huge difference!
What's a good name brand for soldering irons?